Plans for Equipment
Construction of a Bolster, RSA Workshop
- Materials Used:
- 3 large cans with a diameter of about 6", height 7"
- foam 1/4" to 1/2" thick, 22" wide, 26" long
- fabric for cover, e.g. vinyl table cloth or plastic
- tape e.g. duct or strapping tape
- needle and thread
- Directions:
- Clean cans and place them in a row, with solid sides on the outside.
- Tape the cans together.
- Wrap the foam around the cans and hold tight.
- Overlap the foam around the edges of the cans and secure with tape.
- Cut fabric to fit, about 28" by 30".
- Sew a one inch seam on each side of the fabric.
- Insert a long piece of string or a shoelace into the seam, using a safety pin to guide it through.
- Place the fabric securely around the roll and fold under about an inch.
- Sew along the length of the roll to secure the fabric.
- On each end of the roll, pull the drawstring to tighten the ends.
- Tie firm knots and tuck the string ends back inside the fabric.
- Documentation
| Supported by: |
 |
